Filter
Top Products
G0605X/G0606X Extreme Series 12" Table Saw
-47-
Table Saw Operations
Symptom Possible Cause Possible Solution
Machine has vibra-
tion or noisy opera
-
tion.
1. Motor or component is loose.
2. Flat belt worn or loose.
3. Motor fan is rubbing on fan cover.
4. Pulley is loose.
5. Machine sits unevenly on floor.
6. Arbor bearings are at fault.
7. Arbor pulley is loose.
8. Motor bearings are at fault.
9. Blade is at fault.
10. Loose arbor nut
11. Centrifugal switch (G0605X only).
1. Inspect/replace stripped or damaged bolts/nuts, and
re-tighten with thread locking fluid.
2. Inspect/replace flat belt with new one (refer to
Page
48).
3. Replace dented fan cover; replace loose/damaged
fan.
4. Realign/replace shaft, pulley, set screw, and key as
required.
5. Relocate/shim machine.
6. Replace arbor housing bearings; replace arbor.
7. Retighten/replace arbor pulley with shaft and thread
locking liquid.
8. Test by rotating shaft; rotational grinding/loose shaft
requires bearing replacement.
9. Replace warped, bent, or twisted blade; resharpen
dull blade.
10. Tighten the arbor nut.
11. Replace centrifugal switch.
Symptom Possible Cause Possible Solution
Blade is not aligned
with miter slot or
fence.
1. Blade is warped.
2. Table top is not parallel to blade.
3. Fence is not parallel to blade.
1. Replace blade (
Page 22).
2. Make table parallel to blade (
Page 52).
3. Make fence parallel to blade (
Page 54).
Blade does not
reach 90°.
1. 90° stop bolt is out of adjustment.
2. Sawdust loaded up on positive stop.
1. Adjust 90° stop bolt (
Page 50).
2. Clean sawdust off positive stop.
Blade hits insert at
45°.
1. 45° stop bolt is out of adjustment.
2. Hole in insert is inadequate.
3. Table out of alignment.
4. Blade position is incorrect.
1. Adjust 45° stop bolt (
Page 50).
2. File or mill the hole in the insert.
3. Align blade to the table (
Page 52).
4. Adjust blade position.
Board binds or
burns when feeding
through tablesaw.
1. Dull blade.
2. Blade is warped.
3. Fence is not parallel to blade.
4. Table top is not parallel to blade.
1. Replace blade.
2. Replace blade (
Page 22).
3. Make fence parallel to blade (
Page 54).
4. Make table parallel to blade (
Page 52).