Filter
Top Products
G0619 DELUXE SMALL MILL/DRILL
-19-
Figure 17. Table locks and scales.
Table Travel
(X-Axis and Y-Axis)
The mill/drill table can be moved in the X-axis and
Y-axis.
Longitudinal Feed
The longitudinal feed or (X-axis) is moved by the
handwheel shown in Figure 16 at the end of the
table. The handwheel will move the table in both
directions side-to-side. One complete revolution of
the handwheel moves the longitudinal feed 0.100".
There is also a scale on the front of the table for
use when a tight tolerance is not required. The
longitudinal feed can be locked in position by a
table lock located on the front of the table
(see
Figure 17).
Cross Feed
The cross feed or (Y-axis) in Figure 16
, is moved
with the handwheel on the front of the table base.
One complete revolution of the handwheel moves
the cross slide 0.100". The cross feed can be
locked into position by a table lock located on the
right side of the cross slide underneath the table
(see Figure 17).
Figure 16. Table X and Y-axis controls.
Y-Axis Handwheel
X-Axis Handwheel
X-Axis Table Lock
X-Axis Scale
Y-Axis Table Lock Lever
Y-Axis Scale