Filter
Top Products
G0619 DELUXE SMALL MILL/DRILL
-25-
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person
-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
:
• Mill/drill is disconnected from power when not
in use.
• Loose mounting bolts.
• Mill/drill is clean and lubricated.
• Worn or damaged wires.
• Any other unsafe condition.
Monthly Check:
• Gibs are adjusted properly.
Annual or Biannual Check:
• Lubricate headstock lead screw and gears.
Schedule
Regular lubrication will ensure your mill/drill per-
forms at its highest potential
. Place two to three
drops of
a general machine oil directly on the
ways of the cross slide and saddle. An oil bottle
has been provided for this purpose.
Nine ball oil-
ers
(Figures 29–31) should be lubricated daily
with several drops of oil.
Protect the unpainted cast iron surfaces with
regular applications of products like G96
®
Gun
Treatment, SLIPIT
®
, or Boeshield
®
T-9.
Lubrication
Figure 29. Headstock ball oiler locations.
Figure 30. Table and base ball oiler locations.
Figure 31. Table ball oiler location.
One on Each Side