Filter
Top Products
-20-
G0619 DELUXE SMALL MILL/DRILL
Control Panel
It is vital that you become familiar with the power
controls before operating the Model G0619 (see
Figure
18).
Figure 18. Control panel.
A. Spindle
RPM Display: Shows spindle RPM
with an accuracy of +/- 10%.
B.
Spindle Rotation Mode: Shows the direc-
tion the spindle is turning.
C. Spindle Mode
: Shows STOP when the
spindle is stopped. When spindle is rotating,
the "STOP" indication disappears.
D. Spindle START Button
: Press START, and
the spindle will rotate at 200 RPM in the mill
-
ing/drilling mode, and the spindle rotation
buttons on the control panel are enabled.
The Green LED tapping lamp will not glow,
and the spindle rotation buttons on the ends
of the rack handles are disabled.
E. SPEED
Buttons: Press to select a milling/
drilling or tapping RPM. In the milling/drilling
mode the range is between 200 and 1750
RPM. In the tapping mode, the range is
between 100 and 500 RPM.
F.
Spindle Rotation Buttons: Press these
buttons to change spindle rotation direction
for milling/drilling operations. Spindle direc
-
tion can be changed at any RPM without
stopping the spindle first.
G. Spindle STOP Button
: Stops spindle rota-
tion. If you press the START button, the
spindle speed will return to the last spindle
RPM setting.
H. Tapping Button
: Switches the mill/drill into
tapping mode only when the motor is run
-
ning. When in tapping mode, the LED tapping
lamp glows and the RPM automatically drops
to approximately 500 RPM. The spindle rota
-
tion buttons on the ends of the rack handles
are also enabled and the spindle rotation
buttons on the control panel are disabled.
I. Green LED Lamp
: Glows when the machine
is in the tapping mode, and does not glow in
the milling/drilling mode.
J. Emergency Stop Button
: Stops the mill/
drill. Rotate the button clockwise until it pops
back out to reset it.
K. Green Main Power Lamp
: Glows when the
main power switch is turned to the to the ON
position.
L. Digital Spindle Scale ON/OFF Button
:
Turns the digital spindle scale ON or OFF.
M. Spindle
Height Digital Display: Shows
height of spindle.
N. Zero Button
: Zeros the digital spindle scale.
O. mm/in Button
: Toggles units of measure
between metric and inch conventions.
P. Plus Minus Buttons
: Allows you to adjust
digital display value without moving the spin
-
dle or pressing the zero button.
A
B
I
H
F
G
K
L
N
P
O
M
J
D
E
C