Filter
Top Products
-22-
Model G0771 (Mfd. Since 8/15)
22. Nudge fence rail so zero mark of scale on
right lines up with cross-hair in fence scale
window (see Figure 33).
23. Tighten hex nuts to secure fence rail.
24. Check fence scale calibration by moving
fence to 1" mark on scale and measuring
distance from blade (see Figure 34).
—If crosshair aligns exactly with 1" mark, no
adjustments need to be made.
—If crosshair does not align with 1" mark,
loosen fence scale window screws, move
crosshair over 1" mark, then tighten screws.
Figure 34. Checking calibration of fence scale.
25. Lower blade and move fence to left side of
blade.
26. Raise blade 1–2 inches.
27. Slide fence so it lightly touches left side of
blade.
Figure 33. Fence scale calibration.
Fence Lightly
Touching Blade
Fence Scale
Window
18. Place rear of fence over lip of rear fence rail,
then press front of fence into channel of front
fence rail (see Figure 31).
19. Using blade height handwheel, raise blade
1–2 inches.
20. Turn blade tilt handwheel until blade tilt
indicator on front of machine points to 0° on
blade angle scale (see Figure 32).
Figure 31. Fence installed.
17. Install fence handle using flat head screw-
driver (see Figure 30).
Figure 30. Installing fence handle.
21. Slide fence so it lightly touches right side of
blade (see Figure 33). Do not lock fence.
Figure 32. Blade tilt indicator and angle scale.
Blade Tilt Indicator
Blade Tilt
Handwheel