Filter
Top Products
-24-
Model G0771 (Mfd. Since 8/15)
Figure 39. Example of dust hose attached to
dust port.
Dust Collection
To connect a dust collection hose:
1. Fit 4" dust hose over dust port, as shown in
Figure 39, and secure in place with a hose
clamp.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper per-
formance.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
Te st Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
To test run machine:
1. Make sure you have read safety instructions
at beginning of manual and that machine is
set up properly.
2. Lower blade all the way down, and make sure
all tools and objects used during setup are
cleared away from machine.
3. Connect machine to power source.
4. Turn machine ON, verify motor operation,
then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.