Filter
Top Products
G8621 Heavy-Duty Sliding Table Shaper -11-
SECTION 4: ASSEMBLY
Beginning Assembly
Most of your Model G8621 Shaper has been
assembled at the factory, but some parts must be
assembled or installed after delivery. We have
organized the assembly process into steps.
Please follow along in the order presented here.
Handwheel
The handwheel, pre-installed at the factory, is
made of cast iron. It is used to raise and lower the
spindle to accommodate the height required by
your cutter.
Thread the crank handle onto the handwheel.
Figure 4. Handwheel mounted to shaper.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.