Filter
Top Products
-6- G8621 Heavy-Duty Sliding Table Shaper
We do not recommend the use of extension
cords on 220V equipment. Arrange the place-
ment of your equipment and the installed wiring
to eliminate the need for extension cords. Should
it be necessary to use an extension make sure
the cord is rated Hard Service (grade S) or bet-
ter. Refer to the chart in Section 1: Safety to
determine the minimum gauge for the extension
cord. The extension cord must also contain a
ground wire and plug pin. Always repair or
replace extension cords when they become worn
or damaged.
Extension Cords
A wiring diagram is provided at the back of this
manual should it be necessary to repair or revise
the wiring. Always utilize a qualified electrician
when doing any electrical work on this equip-
ment.
Wiring
We have covered some basic electrical
requirements for the safe operation of
your machine. These requirements are not
necessarily comprehensive. You must be
sure that your particular electrical configu-
ration complies with local and state codes.
Ensure compliance by checking with your
local municipality or a licensed electrician.