Filter
Top Products
-22- G8621 Heavy-Duty Sliding Table Shaper
Never use the Model G8621 for applications
other than those for which it was intended.
DO NOT overload the machine or use
excessive force when shaping materials.
Severe personal injury, damage to the
machine, or damage to your workpiece
could occur.
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to start
the machine.
DO NOT have a cutter installed when you test run
the shaper. Turn on the power supply at the main
panel. Press the ON button. Make sure that your
finger is poised on the OFF button, just in case
there is a problem. The shaper should run
smoothly with little or no vibration or rubbing nois-
es. Strange or unnatural noises should be inves-
tigated and corrected before operating the
machine further.
If the shaper seems to be running correctly,
check the directional switch. The spindle should
be rotating in a counterclockwise direction when
the switch is in the FWD position. Run the Model
G8621 for a short time to ensure that the moving
parts are working properly with no excessive
vibration. If any problem develops, correct it
before attempting to use the machine.
If you cannot locate the source of unusual noises,
immediately contact our service department for
help.
Test Run
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.