Filter
Top Products
14 of 50 Operating Information - 3650 Portable O2 Analyzer
Operator Manual
ORBISPHERE
To start the instrument, press the keyboard POWER switch. When you turn power on,
the instrument displays its model number briefly, and then starts in measurement mode.
You can access other instrument functions by pushing one of these keys while turning
power on:
Once you have completed the installation and start-up procedures defined in
“Installation” on page 7, the analyzer can be operated independently, making
measurements as a portable analyzer. You may store these measurement values for
later analysis via the WinLog97 program (on your personal computer) or the memory
view mode (on the instrument). The WinLog97 program operation is described in detail
throughout the manual, where relevant.
Stores a measurement value into memory
Backlights the LCD for approximately three minutes
Toggles between gas concentration and temperature measurement
displays in measurement mode, increases or decreases the storage
number during storage or memory view, or sets a calibration value
during calibration
Sensor calibration - see “Calibrations” on page 31
Start automatic data acquisition - see “Automatic Data Acquisition” on
page 16
Start memory storage view - see “Viewing Stored Measurements” on
page 18
Display program identification information