Filter
Top Products
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
Page 24SKU 55525
WHEN THE WELD IS COMPLETED
Lift the Welding Wire completely away from any grounded object. Set the face shield
down. Then, turn the Power Switch to its “OFF” position.
Unplug the Power Cord (13) from the electrical outlet. Then, make sure to set the
Welding Torch (15) on a nonflammable, nonconductive surface.
NOTE: The wire brush/hammer can now be used to clean up the weld.
CAUTION! The weld may still be quite hot, and sparks/chips may fly
when cleaning. Make sure to continue wearing ANSI-approved safety
impact eye goggles and other protective wear when cleaning a weld.
The hammer can be used to knock off any excess spatter and to help knock down
any ridges. Make sure not to damage the weld or material when striking it.
The wire brush can then be used to help remove oxidation and some fine spat-
ter.
21.
22.
23.
1.
a.
b.