Filter
Top Products
SKU 93380 For technical questions, please call 1-800-444-3353. Page 13
2. Open the Motor Cover (2), and remove the four Screws at the bottom of the
Cabinet (1). Then, remove the large steel plate from the bottom of the Cabinet.
(See Figures D and E.)
3. After removing the large steel plate, you will find two Cap Bolts were screwed
through the bottom of the Cabinet (1) and into the pallet. Use a wrench (not
included) to remove the two Cap Bolts. (See Figure E.)
4. You may now lift (using proper lifting devices) the Table Saw up and off the pallet.
Clean Up:
1. To avoid rust, the unpainted surfaces of the Table Saw have been factory-coated
with a waxy oil during shipment. Remove the waxy oil with a solvent or citrus-
based de-greaser. NOTE: Chlorine-based cleaners and solvents will damage the
painted surfaces of the Table Saw.
Motor Brace Disassembly:
1. A red Motor brace has been installed for shipping purposes. Remove this brace
before continuing with assembly. The Bolts that secure the brace should be
screwed back in at the locations from which they came. (See Figure F.)
MOTOR BRACE
FIGURE F
FIGURE E