Filter
Top Products
SKU 93380 For technical questions, please call 1-800-444-3353. Page 8
back as the Table Saw is restarted.
* Support large panels with roller stands (not included) to minimize the risk
of Saw Blade pinching and kickback. Large panels tend to sag under their
own weight. Supports must be placed under the panel and near the outer
edge of the panel.
* Do not use a dull or damaged Saw Blade. Unsharpened or improperly set
Saw Blades produce a narrow kerf causing excessive friction, Saw Blade
binding and kickback.
* Never use the Fence assembly as a guide when crosscutting.
* Never rip a woodstock that is twisted or warped, or does not have a
straight edge to guide along the Rip Fence.
* Push the woodstock past the Saw Blade prior to release.
29. Check all guards for proper operation before each use. Never disable
guards. Do not operate the Table Saw if the guard assembly does not move
freely and close instantly. Before each use, raise the guard assembly and
make sure it moves freely and does not touch the Saw Blade or any other
part, in all angles and depths of cut.
30. Never perform layout, assembly, or setup work on the Table of the Table
Saw when the machine is running.
31. Always disconnect the Table Saw from its electrical outlet before performing
any services, maintenance, or cleaning such as leaving the work area, mov-
ing the machine from one location to another, changing Saw Blades, cleaning
sawdust from the machine, etc.
32. Make sure to remove all adjusting wrenches from the Table Saw before
turning it on.
33. Use a “push stick” or “auxiliary handle” (neither included) only when ripping
widths of 2” to 6”. Use a “push block” and “auxiliary fence” (neither included)
when ripping widths under 2”.
34. Keep the Table of the Table Saw clean and clear of debris. Remove cut-off
pieces and scraps of wood from the Table before starting the Table Saw.
35. Use the right tool for the job. Do not attempt to force small equipment to do
the work of larger industrial equipment. There are certain applications for which
this Table Saw was designed. It will do the job better and more safely at the rate