Filter
Top Products
SKU 93380 For technical questions, please call 1-800-444-3353. Page 15
To Install The Clean Out Door And Dust Hood:
1. Mount the Clean Out Door (12) into the square hole located on the lower left side
of the Cabinet (1). (See Figure H.)
2. Attach the Dust Hood (14) to the Clean Out Door (12), using four Self-Tapping
Screws (13). (See Figure H.)
3. NOTE: Make sure to orient the Dust Hood (14) so the 4” flange is on the lower
half of the Dust Hood when installed. (See Figure H.)
Note: A dust collector (not included) may be attached to the hood, using a 4”
hose.
FIGURE H
CLEAN OUT DOOR
(12)
DUST HOOD
(14)
SELF-TAPPING SCREW
(13)
To Attach The Front And Rear Fence Rails:
1. Align the mounting holes in the Front Rail (23B) with the mounting holes on the
front edges of the Left Wing (113), Main Table (115), and Right Wing (114). Use
four Bolts (27B), four Elastic Washers (26B), and four Flat Washers (25B) to
secure the Front Rail to the Left Wing, Main Table, and Right Wing.
NOTE: Make sure the top of the Front Rail is flush with the top of the Left Wing,
Main Table, and Right Wing. (See Figure I.)
2. Repeat Step #1 above to attach the Rear Rail (24B) to the rear edges of the Left
Wing, Main Table, and Right Wing. (See Figure I.)
BOLT (27B)
ELASTIC WASHER (26B)
FLAT WASHER (25B)
FIGURE I