Filter
Top Products
SKU 93380 For technical questions, please call 1-800-444-3353. Page 20
SCREW (135)
POWER SWITCH
(137)
ON
OFF
FIGURE O
ADJUSTMENTS
To Adjust The Splitter And Blade Guard Assembly:
1. Set a machinist’s square against the face of the Splitter (315). Slightly rotate the
rear bracket to adjust the face of the Splitter perpendicular to the Main Table
(115). (See Figure P.)
2. Raise the Blade Guard Assembly away from the Main Table (115) and hold the
anti-kickback Pawls (313) away from the Main Table surface. (See Figure P.)
3. Using an accurate straight edge, align the Splitter (315) with the Saw Blade.
Make sure the straight edge rests against the side of the Saw Blade.
(See Figure Q.)
FIGURE P
FIGURE Q