Filter
Top Products
Page 15SKU 97009 For technical questions, please call 1-800-444-3353.
TO CONVERT THE BANDSAW FOR VERTICAL USE
NOTE: Notching, slitting, and contour work is best done with the Bandsaw in its
vertical position.
Raise the Saw Head to its full vertical position, making sure it locks into position
by turning the Cylinder’s (216) on/off valve to its “OFF” position (the spoke to be
positioned cross the cylinder). (See Figure H.)
1.
2.
THUMB SCREW
(38)
STOCK
STOP ROD
(40)
STOP BLOCK
(41)
WORKPIECE
(NOT INCLUDED)
FIGURE G
CYLINDER (216)
FIGURE H