Filter
Top Products
Page 25SKU 97009 For technical questions, please call 1-800-444-3353.
IMPORTANT: When in the horizontal cutting mode only, the Motor Toggle Switch
(750S4) will automatically turn to its “OFF” position and shut off the Bandsaw’s
Motor when the cut has been completed. (See Figure T.)
Once the cut is made, and the motor is switched off, turn the Coolant Pump
Toggle Switch (750S2) to its “OFF” position. Turn the Coolant Pump Fitting
(91S) to its “CLOSED” position. Then unplug the Power Cable (500) from its
electrical outlet. (See Figure T.)
Wait until the Saw Blade (251) comes to a complete stop. Then raise the Saw
Head to its full vertical position. Turn the Cylinder (216) to its “OFF” position
to lock the Saw Head in place. Remove the workpiece from the Vise (9, 22)
assembly and scrap material from the Base (1) of the Bandsaw. (See Figure T.)
Turn the Cylinder (216) to its “ON” position. Slowly lower the Saw Head to its
horizontal position. Then turn the Cylinder to its “OFF” position to lock the Saw
Head in place. (See Figure T.)
13.
14.
15.
16.
MAINTENANCE AND SERVICING
Risk of serious personal injury from accidental starting or
electric shock. Turn the Power Switch of the Bandsaw to its
“OFF” position and unplug the tool from its electrical outlet
before performing any inspection, maintenance, or cleaning
procedures.
Damaged equipment can fail, causing serious personal
injury. Do not use damaged equipment. If abnormal noise or
vibration occurs, have the problem corrected before further
use.
INSPECTION, MAINTENANCE, AND CLEANING
Before each use, inspect the general condition of the Bandsaw. Check for
loose screws, misalignment or binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other condition that may affect its safe
operation. Do not use damaged equipment.
Before each use, inspect the Saw Blade (251). Using a dull Saw Blade will
cause excessive wear on the Motor of the Bandsaw and will not produce a
satisfactory cut. Replace with a new Saw Blade when needed. To replace the
Saw Blade:
NOTE: Make sure to wear heavy duty work gloves to avoid accidental injury
from the Saw Blade (251) when performing this procedure.
1.
2.
•
WARNINGWARNING