Filter
Top Products
Page 22SKU 97009 For technical questions, please call 1-800-444-3353.
Turn the Coolant Pump Fitting (91S) to its “OPEN” position. Then turn the
Coolant Pump Toggle Switch (750S2) to its “ON” position. (See Figure S.)
Turn the Motor Toggle Switch (750S4) to its “ON” position. (See Figure S.)
Set the workpiece on the Vertical Saw Table (55-2), making sure to keep
downward pressure on the workpiece throughout the cutting process. (See
Figure S.)
When cutting a large workpiece, make sure its entire length is properly
supported. If necessary, use a roller stand (not included) with a large workpiece.
Allow the Saw Blade (251) to turn up to full speed before feeding the workpiece
into the Blade. (See Figure S.)
Feed the workpiece into the Saw Blade (251) gradually. Do not force the
Bandsaw to remove material faster than it is designed to cut. (See Figure S.)
5.
6.
7.
8.
9.
10.
SAW HEAD ASSY.
COOLANT PUMP FITTING (91S)
SAW BLADE (251)
VERTICAL SAW TABLE (55-2)
MOTOR TOGGLE SWITCH (750S4)
COOLANT PUMP
TOGGLE SWITCH
(750S2)
CYLINDER (216)
FIGURE S