Filter
Top Products
Page 24SKU 97009 For technical questions, please call 1-800-444-3353.
Plug the Power Cable (500) into the nearest 120 volt, grounded, electrical
outlet. NOTE: If the Bandsaw has been re-wired to operate on a 240 volt
system then plug the Power Cord into the nearest 240 volt, grounded, electrical
outlet.
Turn the Coolant Pump Fitting (91S) to its “OPEN” position. Then turn the
Coolant Pump Toggle Switch (750S2) to its “ON” position. (See Figure T.)
Turn the Motor Toggle Switch (750S4) to its “ON” position. (See Figure T.)
Turn the Cylinder to its “ON” position, and slowly lower the Saw Head until the
Saw Blade (251) is just above the workpiece cut line. (See Figure T.)
Allow the Saw Blade (251) to turn up to full speed before feeding the Blade into
the workpiece. (See Figure T.)
Through the Hydraulic Feed System, allow the Saw Arm to lower, while it
gradually feeds the Saw Blade (251) into the workpiece. Do not force the
Bandsaw to remove material faster than it was designed to cut. NOTE: The
speed at which the Saw Arm moves downward may be increased or decreased
by adjusting the Bleed Valve on the Cylinder (216). (See Figure T.)
Never attempt to remove material stuck in the moving parts of the Bandsaw
while it is plugged in and running. Turn off the Bandsaw if the workpiece is to be
backed out of an uncompleted cut.
6.
7.
8.
9.
10.
11.
12.
FIGURE T
COOLANT PUMP FITTING
(91S)
SAW HEAD ASSY.
CYLINDER (216)
COOLANT PUMP TOGGLE SWITCH
(750S2)
MOTOR
TOGGLE SWITCH
(750S4)