Filter
Top Products
Page 7SKU 97009 For technical questions, please call 1-800-444-3353.
When cutting magnesium, use soluble oils or emulsions (oil/water mix) as water
only will greatly intensify any accidental magnesium chip re. See your industrial
coolant supplier for specic coolant recommendations when cutting magnesium.
Avoid unintentional starting. Prepare to begin work before turning on the tool.
Do not leave the tool unattended when it is plugged into an electrical outlet. Turn
off the tool, and unplug it from its electrical outlet before leaving.
Use the Vise or other practical ways to secure and support the workpiece to the
Support Plate. Holding the work by hand or against your body is unstable and
may lead to loss of control, and personal injury.
This product is not a toy. Keep it out of reach of children.
The brass components of this product contain lead, a chemical known to the
State of California to cause birth defects (or other reproductive harm). California
Health & Safety Code 25249.5, et seq.)
People with pacemakers should consult their physician(s) before use.
Electromagnetic elds in close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure. In addition, people with
pacemakers should:
• Avoid operating alone.
• Do not use with power switch locked on.
• Properly maintain and inspect to avoid electrical shock.
• Any power cord must be properly grounded. Ground Fault Circuit Interrupter
(GFCI) should also be implemented – it prevents sustained electrical shock.
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities, contains chemicals known [to the State of California] to
cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
Lead from lead-based paints
Crystalline silica from bricks and cement or other masonry products
Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type
of work. To reduce your exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such as those dust masks that
are specially designed to lter out microscopic particles. (California Health &
Safety Code § 25249.5, et seq.)
The warnings, precautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
18.
19.
20.
21.
22.
23.
24.
25.
26.