Filter
Top Products
SKU 98198 For technical questions, please call 1-800-444-3353. Page 10
with two M8-1.25 x 15 Carriage Bolts
(268) and Flanged Nuts (269).
Do not tighten the screws to the c.
Stand until its assembly is complete.
Completed Stand
Fig. 2.
d. Repeat this assembly process with
the other three legs, using the sup-
plied hardware, until the Stand (263)
assembly is complete. (See Fig. 2.)
Mounting
Attach drum sander to stand.
a.
the Hand Wheel (103) facing up.
With the Stand (263) on its side, b.
point the Stand’s top toward the
sander’s bottom,
Move the Stand up against the bot-c.
tom of the sander and align holes.
Bolt the Sander to the Stand using d.
Washers (272) in four places.
With bolts securely tightened and e.
the help of another person, tilt the
Final Assembly
Attach components.
Screw the Hand Wheel Handle onto a.
the Hand Wheel (103).
Attach Hand Wheel (103) with a Hex b.
Socket HD Screw (239) and Flat
Washer (238).
Attach the Square Dust Port (56).c.
Attach the Square-To-Round Dust d.
Chute (59) Adapter and Dust Chute
(70).
Attach the Dust Bag (273).e.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
The initial setup and adjustment of 1.
the following have been done at the
factory:
V-Belt tensioning.a.
Feed Belt tensioning and tracking.b.
Table adjustments.c.