Harbor Freight Tools 98198 Sander User Manual


  Open as PDF
of 27
 
SKU 98198 For technical questions, please call 1-800-444-3353. Page 22
Problem Possible Causes Likely Solutions
Sandpaper on
Drum tears
during operation
1.
workpiece.
Sandpaper not tightened or 2.
fastened correctly.
Sand only clean workpieces. 1.
Install the sandpaper correctly.2.
Table elevation
controls are
stiff and hard to
adjust.
Table lift screws are dirty or 1.
loaded with sawdust.
Chain idler sprocket Cap Screws 2.
have been over tightened.
Elevation handle helical gear is 3.
dirty or loaded with sawdust.
Clean and re-grease table lift screws. 1.
Adjust the Cap Screws on the Idler Sprocket 2.
so it can rotate freely.
Clean and re-grease the Helical Cut Gear 3.
(113).
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY


DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT







 previous next