Filter
Top Products
Page 11SKU 91815
Assembling the Saw to the Stand
Caution: The Table Saw body is very heavy and needs two people to lift. Use care when
lifting. Failure to comply may cause serious injury and damage to equipment.
1. With the help of another person, carefully lift the saw body out of the shipping box and
set on the ground.
2. Remove the protect wrapping from the saw top and wipe the saw top clean with a soft
cloth.
3. Lift the saw body and place upside down on a protective surface (For example, place
on a flattened cardboard box.).
4. Place the previously assembled Stand upside down on the saw body bottom. Note
that the label on the Stand must face forward or toward the front of the saw body.
5. Align the mounting holes in the Stand with those on the saw body bottom and secure
using four 5/16” x 3/4” Cap Bolts (38), eight 5/16 x 23mm Flat Washers (45), four
5/16” Lock Washers (39), and four 5/16” Hex Nuts (58). Refer to Figure D., below.
6. Securely tighten the hardware attaching the saw body to the Stand. Do not tighten the
Stand hardware until the saw is placed on its feet.
7. With the help of another person, carefully lift and turn the saw over onto the Stand
feet.
8. Level the saw body by moving it back and forth until the saw body is sitting level and
squarely on the Stand feet.
9. Securely tighten all Stand hardware.
Figure D. Stand-to-Saw Assembly