Filter
Top Products
Page 12SKU 91815
Extension Wing Assembly
1. Bolt the right Extension Wing (76) to the Table (22) with three 5/16” x 1” Hex Cap Bolts
(75), 5/16 x 23mm Flat Washers (45), and 5/16” Lock Washers (39). Refer to Figures
E and F, below.
Hand tighten enough to hold the wing in place and allow for adjustment.
2. Place a “carpenter’s level” (not included) on the Table so that it hangs over the edge of
the wing approximately one inch.
3. Bring the edge of the wing flush to the edge of the Table top, then tighten the Hex Cap
Bolts when the (corner) lead edge of the wing is also flush with the Table from front to
back.
4. Repeat steps one through four with the left Extension Wing (76).
Figure E. Wing Assembly
Figure F. Wing and Rail Assembly
Right Extension Wing (76)
Left Extension Wing (76)