Filter
Top Products
OM-1594 Page 34
Ref. 151 599-C / Ref. 802 652 / Ref. 801 556 / 801 564 / Ref. 151 666-A / Ref. 200 371
6-5. Replacing Gun Cable Liner
Y Turn Off welding power
source and wire feeder.
1 Drive Roll
2 Collet Nut
Lay gun cable out straight. Remove
drive roll on gun and loosen collet
nut on liner tube assembly.
3 Gun Connector
Remove inlet guide from gun con-
nector, and remove old liner.
4 New Liner
Insert split end of new liner into gun
connector and continue feeding lin-
er through cable assembly until lin-
er is through collet and all of split
portion is visible.
Cut off split portion of liner. Position
liner as close as possible to drive
rolls without touching them. Tighten
collet nut. Reinstall inlet guide at
gun connector and tighten onto lin-
er.
Cut liner as close as possible to
control (push motor) drive rolls.
See Section 4-14 for instructions on
rethreading wire.
XR-Edge Gun
Split End
2
1
1
3
Pistol Grip Gun
3
4
2