Filter
Top Products
8
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Drum
Sander is assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
1 Drum Sander with stand – A
1 Conveyor Bed Assembly – B
2 Assembly Fixtures – C
1 Handwheel – D
1 Handwheel Knob – E
4 Legs – F
4 Leg Glides – G
8 Hex Head Bolts, 3/8”x1-1/2” – H
4 Hex Head Bolts, 3/8”x1” – J
12 Flanged Lock Nuts, 3/8” – K
20 Flat Washers, 3/8” – L
8 Hex Nuts, 3/8” – M
2 Drum Alignment Templates – N
2 Open-end Wrenches, 9/16”-1/2” – O
2 Hex Wrenches, 4mm and 1/8” – P
1 TufTool – R
1 Owner's Manual (not shown)
1 Warranty Card (not shown)
Figure 2
Read and understand the entire contents of this manual before attempting set-up
or operation! Failure to comply may cause serious injury.