LevelOne FBR-1100TX Grinder User Manual


 
LevelOne Broadband Router User Guide
6
using the factory default values.
6
Power port (12V) Connect the power adapter here.
7
WAN Data
LED
This will flash during normal operation, when data is trans-
mitted or received through the WAN port.
8
LAN Data/Status LED During normal operation, this will flash in Green. Orange
indicates an error. See the following LED Table for more
information.
9
DIP switches
Refer to the following table.
DIP switches
DIP Switch Setting Description
1=off
2=off
Normal Operation.
1=off
2=on
DHCP Server function disabled.
1=on
2=off
Used to restore Default IP Address
and clear Password (See below).
1=on
2=on
Normal Operation.
Restore Default IP Address and Clear Password
If the LevelOne Broadband Router's IP Address or password is lost, the following procedure
can be used to recover from this situation.
1. Turn the power to the LevelOne Broadband Router OFF.
2. Set DIP switch 1 ON.
3. Turn the power to the LevelOne Broadband Router ON.
4. Operate DIP switch 1 in the following sequence (you have 15 seconds to complete the
sequence):
OFF
ON
OFF
5. The LevelOne Broadband Router will now reset, and the Red Status LED flash. The follow-
ing changes will have been made. (Other configuration data is unchanged.)
IP Address set to its default value of 192.168.0.1
Network Mask set to 255.255.255.0
DHCP Server is enabled, and will allocate IP Addresses in the range 192.168.0.2 to
192.168.0.51.
The password cleared (no password).