LevelOne FBR-1100TX Grinder User Manual


 
Operation and Status
53
Connection Status - PPPoE
If using PPPoE (PPP over Ethernet), a screen like the following example will be displayed when
the "Connection Details" button is clicked.
Figure 31: PPPoE Status Screen
Data - PPPoE Status Screen
Connection
Physical Address The hardware address of this device, as seen by remote devices
on the Internet. (This is different to the hardware address seen by
devices on the local LAN.)
IP Address The IP Address of this device, as seen by Internet users. This
address is allocated by your ISP (Internet Service Provider).
Network Mask The Network Mask associated with the IP Address above.
PPPoE Link Status This indicates whether or not the connection is currently estab-
lished.
If the connection does not exist, the "Connect" button can be
used to establish a connection.
If the connection currently exists, the "Disconnect" button
can be used to break the connection.
Connection Log
Connection Log
The Connection Log shows status messages relating to the
existing connection.
The most common messages are listed in the table below.
The "Clear Log" button will restart the Log, while the Refresh
button will update the messages shown on screen.