LevelOne FBR-1100TX Grinder User Manual


 
LevelOne Broadband Router User Guide
42
Under Windows 95, if you see the following error message,
either install Internet Explorer 4 or later, or follow the pro-
cedure in the "Trouble Shooting - Printing" section of
Appendix A.
6. A pop-up message will inform you if the port has been created successfully, and then the
Windows Add Printer wizard will start.
Select the correct Printer Manufacturer and Model, or use the "Have Disk" option if
appropriate.
If desired, change the Printer name so it indicates the device used (e.g. HP2100 on
SCA43600)
If prompted about Sharing, do NOT enable Sharing.
7. Installation is now complete. You can now print using this printer.
To install additional Printers (on different devices), repeat steps 6 and 7.
Use the Start menu to run this program in future. The default installation is Start -
Programs - Broadband Internet Router - Add Port.
Management
Print jobs can be managed like any Windows printer. Open the Printers folder (Start -
Settings - Printers) and double-click any printer to see the current print jobs.
If the printer attached to the LevelOne Broadband Router is changed, just run this program
again, and select the correct printer.
To delete a port created by this setup program, use the Windows Delete Port facility:
Right-click any printer in the Printers folder, and select Properties.
Locate the Delete Port button. This button is on the Details or Ports tab, depending
on your version or Windows.
If the LevelOne Broadband Router's IP Address is changed, and you can no longer print,
delete the port (see procedure above) and re-install it.
Port Options
The options for the Print Port Driver are accessed via the Windows Port Settings button.
Use Start - Settings - Printers to open the Printers folder, then right-click the Printer, and select
Properties. The Port Settings button is on the Details or Port tab, depending on your version
of Windows.
An example screen is shown below: