LevelOne Broadband Router User Guide
20
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the LevelOne Broadband Router.
Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a stan-
dard cable.
4. Connect Printer Cable
Use a standard parallel printer cable to connect your printer to the Printer port on the Leve-
lOne Broadband Router.
5. Power Up
• Power on the Cable or DSL modem.
• Power on the Printer.
• Connect the supplied power adapter to the LevelOne Broadband Router and power up.
Use only the power adapter provided. Using a different one may cause hardware damage
6. Check the LEDs
• The Status LED should flash, then turn Off. If it stays On, there is a hardware error.
• The Power and WAN Link LEDs should be ON.
• For each active LAN (PC) connection, the corresponding LED should be ON. (Yellow
indicates 10BaseT, Green indicates 100BaseT.)
• If the printer is On and On-line, the Print Act LED should be ON.
For more information, refer to LEDs - FBR-1700TX in Chapter 1.