Filter
Top Products
Introduction
13
Components - FBR-1700TX
Figure 5: Rear Panel - FBR-1700TX
Power port (9V) Connect the supplied power adapter here.
Uplink Port Use the "Uplink" port ONLY to connect to a normal port on
another hub.
If the "Uplink" port is used, port 7 can not be used.
10/100BaseT
LAN connectors
(Switching hub ports)
Use standard LAN cables (RJ45 connectors) to connect this port
to your PCs. Both 10BaseT and 100BaseT connections can be
used simultaneously.
If port 7 is used, the "Uplink" port can NOT be used.
WAN port
(10BaseT)
Connect the ADSL or Cable Modem here. If your modem came
with a cable, use the supplied cable. Otherwise, use a standard
LAN cable.
Reset Button This button has three (3) functions:
• Reboot. When pressed and released, the Broadband Router
will reboot (restart).
• Diagnostic print-out. If held down for 3 seconds, a diagnos-
tic print-out will be sent to the attached printer.
• Ensure the printer is ready.
• Both Print LEDs will flash simultaneously during the di-
agnostic printing.
• Clear All Data. This button can also be used to clear ALL
data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
• Power Off
• Hold the Reset Button down while you Power On.
• Continue holding the Reset Button until the Status (Red) LED
blinks TWICE.
• Release the Reset Button.
The factory default configuration has now been restored, and
the Broadband Router is ready for use.
DIP switches Refer to the following table.
Printer Port Standard parallel printer port. If you wish to share a printer,
connect it here.