Filter
Top Products
LevelOne Broadband Router User Guide
16
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the LevelOne Broadband Router.
Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a stan-
dard cable.
4. Power Up
• Power on the Cable or DSL modem.
• Connect the supplied power adapter to the LevelOne Broadband Router and power up.
Use only the power adapter provided. Using a different one may cause hardware damage
5. Check the LEDs
• When the LevelOne Broadband Router is powered On, the Data/Status LED should flash
Orange, then turn Green. If it stays Orange, or flashes Orange/Green, there is a hardware
problem.
• The WAN Data LED (on the top) should be ON.
• The LAN Link LED (beside the LAN connection) should be ON.
• The WAN Link LED (beside the WAN connection) should be ON.
For more information, refer to LEDs - FBR-1100TX in Chapter 1.
Installation Procedure - FBR-1400TX
Figure 7: Installation Diagram
1. Choose an Installation Site
Select a suitable place on the network to install the LevelOne Broadband Router.
Ensure the LevelOne Broadband Router and the DSL/Cable modem are powered OFF.