LevelOne FBR-1100TX Grinder User Manual


 
Installation
19
6. Check the LEDs
The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
The Power LED should be ON.
One (1) of the LAN LEDs (10 or 100) should be ON.
The WAN LED should be ON.
If the printer is On and On-line, the Print Act LED should be ON.
For more information, refer to LEDs - FBR-1401TX in Chapter 1.
Installation Procedure - FBR-1700TX
Figure 9: Installation Diagram
1. Choose an Installation Site
Select a suitable place on the network to install the LevelOne Broadband Router.
Ensure the LevelOne Broadband Router and the DSL/Cable modem are powered OFF.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the LevelOne
Broadband Router. Both 10BaseT and 100BaseT connections can be used simultaneously.
If required, use a standard LAN cable to connect the "Uplink" port to a standard port on
another hub.
Note: The "Uplink" port and port 7 can NOT be used simultaneously.