Filter
Top Products
% % ) - )&##*% . )
, *
,)
+$ *) '+ &%
1 Inner Wire Guide
2 Drive Rolls
3 Outer Wire Guide
+A5:3@976D;H7DA>>E3@6I;D79G;67E
1. Turn off power at the welding power source.
2. Open wire drive door.
3. Remove the outer wire guide. (Item #3)
4. Remove the 4 drive rolls (Item #2) by pulling them
straight off of the drive hub. Rock the upper drive
rolls back for ease of removal.
5. Remove the inner wire guide (Item #1).
6. Insert the new inner wire guide (Item #1) over the
locating pins of the feed plate.
7. Install each drive roll by pushing it onto the hub
until it fully seats.
8. Install the outer wire guide.
9. Swing the upper drive rolls down and close the
wire drive door.
WIRE DRIVE DOOR
(OPEN)
%*+##+ &%
'&.)S$* %#. ))
. )) -*0*+$*
Drive Roll Kits are designed to feed specific types and
wire sizes. The Power Feed™ 10M Single Wire
Feeder does not include these Drive Roll Kits with this
Wire Drive, but are available for ordering from the fol-
lowing tables:
D;H7)A>>";FE*F77>.;D7E
Includes: 4 Smooth V groove drive rolls and an inner
wire guide.
KP1505-030S .023-.030 (0.6-0.8mm)
KP1505-035S .035 (0.9mm)
KP1505-045S .045 (1.2mm)
KP1505-052S .052 (1.4mm)
KP1505-1/16S 1/16 (1.6mm)
D;H7)A>>";FEAD76.;D7E
Includes: 4 Knurled drive rolls and an inner wire guide.
KP1505-035C .030-.035" (0.8-0.9mm)
KP1505-045C .040-.045" (1.0-1.2mm)
KP1505-052C .052" (1.4mm)
KP1505-1/16C 1/16" (1.6mm)
D;H7)A>>";FE*F77>ADAD76.;D7E
Includes: 4 Knurled drive rolls and an inner wire guide.
KP1505-068 .068-.072" (1.8mm)
KP1505-5/64 5/64" (2.0mm)
KP1505-3/32 3/32" (2.4mm)
KP1505-7/64 7/64" (2.8mm)
KP1505-.120 .120" (3.2mm)
D;H7)A>>";FE3D6835;@9.;D7E
Includes: 2 Knurled drive rolls, 2 Smooth V groove
drive rolls and an inner wire guide.
KP1505-7/64C 7/64" (2.8mm)
D;H7)A>>";FE>G?;@G?.;D7
Includes: 4 polished U groove drive rolls, outer wire
guide and an inner wire guide.
KP1507-035A .035" (0.9 mm)
KP1507-040A .040" (1.0mm)
KP1507-3/64A 3/64" (1.2mm)
KP1507-1/16A 1/16" (1.6mm)
KP1507-3/32A 3/32" (2.4mm)