Filter
Top Products
EFFECT / RANGE
Postflow Time
0 to 25.0 seconds
Crater Procedure
(0 TO 10.0 SECONDS)
Burnback:
0 to .25 Seconds
Spot Timer:
0 to 120.0 Seconds
DESCRIPTION
Adjusts the time that shielding
gas flows after the welding out-
put turns off.
Crater Procedure controls the
WFS and Volts for a specified
time at the end of the weld
after the trigger is released.
During the Crater time, the
machine will ramp up or down
from the Weld Procedure to
the Crater Procedure.
The burnback time is the
amount of time that the weld
output continues after the wire
stops feeding. It prevents the
wire from sticking in the puddle
and prepares the end of the
wire for the next arc start.
Adjusts the time welding will
continue even if tigger is still
pulled. This option has no
effect in 4-Step Trigger Mode.
%&'+ &%*
$3F7D;3>
Steel
Steel
Steel
')&**
GMAW, CV
GMAW, POWER MODE
FCAW, CV
.#$&
5
40
6
-%&%*0%) $&*
&')+ &%
'&.)S$* %#. ))
DESCRIPTION
Arc Force adjusts the short cir-
cuit current for a soft arc, or for
a forceful, digging arc.
)&%+)&#
300
25.3
WFS AMPS
VOLTS TRIM
LESS
WFS
MORE
WFS
LESS
V
OLTS
MORE
V
OLTS
300
25.3
WFS AMPS
VOLTS TRIM
LESS
WFS
MORE
WFS
LESS
V
OLTS
MORE
V
OLTS
$ %,%+ &%# +00.#')&**
-$..%&%*0%)
Use the following tables to review how the machine functions (output controls, arc control, Start options and weld
options) for the weld modes listed in the top table.
&,+',+&%+)&#"%&*.#$&
200
2.0
W
FS AMPS
VOLTS TRIM
LESS
W
FS
MORE
W
FS
SHORTER
ARC
LONGER
A
RC
200
2.0
W
FS AMPS
VOLTS TRIM
LESS
W
FS
MORE
W
FS
SHORTER
ARC
LONGER
A
RC
&,+',+&%+)&#"%&*.#$&
EFFECT / RANGE
(Soft)-10.0 to
(Crisp)+10.0
EFFECT / RANGE
Preflow Time
0 - 25.0 seconds
Run-In WFS:
Off, 30 to150 in/min.
Start Procedure
0 - 10 seconds
DESCRIPTION
Adjusts the time the gas flows
after the trigger is pulled and
prior to feeding.
Run-In sets the wire feed
speed from the time the trigger
is pulled until an arc is estab-
lished.
The Start Procedure controls
the WFS and Volts for a speci-
fied time at the beginning of
the weld. During the start time,
the machine will ramp up or
down from the Start Procedure
to the preset Welding
Procedure.
*+)+&'+ &%*
The start Options available in these Non-Synergic CV
weld modes, their adjustment range and function are as
follows :