Lincoln Electric IM827-D Welder User Manual


  Open as PDF
of 75
 

$ %+%%

'&.)S$* %#. ))
*+0'),+ &%*
.)% %
&4E7DH73>>366;F;A@3>*387FKG;67>;@7E67F3;>76
F:DAG9:AGFF:;E?3@G3>
#+) *&"53@=;>>
Q A@AFFAG5:7>75FD;53>>K>;H7B3DFEEG5:
3EAGFBGFF7D?;@3>EAD;@F7D@3>I;D;@9
Q
.:7@;@5:;@9I;F:9G@FD;997D7>75FDA673@6
6D;H7?75:3@;E?3D7V:AFWFAIAD=3@6
9DAG@63@65AG>6D7?3;@7@7D9;L76E7H7D3>
E75A@6E38F7DF:79G@FD;997D;ED7>73E76
Q +GD@&;@BGFBAI7D3FI7>6;@9BAI7D
EAGD57478AD7;@EF3>>3F;A@AD5:3@9;@9
6D;H7DA>>3@6AD9G;67FG47E
Q .7>6;@9BAI7DEAGD57?GEF475A@@75F76
FAEKEF7?9DAG@6B7DF:7%3F;A@3>
>75FD;53>A67AD3@K3BB>;534>7>A53>
5A67E
• &@>KCG3>;8;76B7DEA@@7>E:AG>6
B7D8AD??3;@F7@3@57IAD=
)&,+ %$ %+%%
• Check weld cables, control cables and gas hoses
for cuts.
• Clean and tighten all weld terminals.
• Inspect and clean drive rolls and inner wire guide
and replace if worn.
') & $ %+%%
• Blow out or vacuum the inside of the feeder.
• Every six months check the motor brushes.
Replace them if they are less than 1/4" long.
• Every year inspect the gearbox and coat the gear
teeth with a moly-disulfide filled grease. DO NOT
use graphite grease.
# )+ &%*'  + &%
All calibration is factory set on the Power Feed™ 10M
Single Wire Feeder.
To verify the wire feed speed:
• Assemble a .045 (1.2mm) drive roll kit into the
Power Feed™ 10M Single Wire Feeder.
• Load a spool of .045 (1.2mm) electrode and thread
the electrode through the wire drive.
• Adjust the wire feed speed to 300 in/min
(7.62m/min).
• Press the COLD FEED switch and measure the
actual wire feed speed with a calibrated wire feed
speed tachometer.
• The measured wire feed speed should be within
±2% of the set value.
 previous next