Filter
Top Products
%*+##+ &%
'&.)S$* %#. ))
,E;@9"A;>)77>
50-60 lb. (22.7 - 27.2 kg) Coil Mounting
(See Figure A.10)
1. Make sure the spindle of the wire reel stand is in
the upper position.
2. With the coil reel assembly mounted to a 2" (51mm)
spindle, loosen the spinner nut and remove the
cover plate. Alternatively, lay the coil reel assembly
flat on the floor and loosen the spinner nut and
remove the cover plate.
3. Place the coil of electrode on the reel so it unwinds
from the bottom as it rotates.
4. Tighten the spinner nut as much as possible by
hand using the cover plate spokes for leverage.
DO NOT hammer on the spinner nut.
5. Cut and remove only the tie wire holding the free
end of the coil. Hook the free end around the rim of
the cover plate and secure it by wrapping it around.
Cut and remove remaining tie wires.
Q>I3KE47EGD7F:78D777@6A8F:75A;>;EE75GD7
>K:7>6I:;>7F:7F;7I;D7E3D747;@95GF3@6G@F;>
F:7I;D7;E8776;@9F:DAG9:F:76D;H7DA>>E
3;>GD7FA6AF:;EI;>>D7EG>F;@435=>3E:;@9A8
F:75A;>I:;5:?3KF3@9>7F:7I;D7F3@9>76
5A;>I;>>@AF87763@6?GEF7;F:7D47G@F3@9>76AD
6;E53D676
----------------------------------------------------------------------------------------
6. Be sure the coil is engaged with the spindle brake
pin and the release bar on the retaining collar "pops
up". The retaining collar must fully engage the
retaining groove on the spindle.
,+ &%
SPINNER
NUT
CARDBOARD
LINER
COVER
PLATE
TIE
WIRE
SPRING
ARM
REEL
COIL
SLOTS
,)