Filter
Top Products
F-65
TROUBLESHOOTING & REPAIR
F-65
TEST PROCEDURE
1. Remove input power to the NA-5.
2. Using the 5/16" nutdriver open the
control box PC board access door.
3. Locate the voltmeter PC board. See
Figure F.9
4. Apply input power to the NA-5.
5. Test for AC supply to the volt-
meter PC board.
• Check for 8 to 11VAC from lead
#601 to #602. See Figure F.9
Note: The coating will have to be
removed from the test points to ensure
accurate voltmeter readings. If the cor-
rect AC voltage is not present check for
loose or faulty connects with the associ-
ated leads. See wiring diagram.
METER CIRCUIT ACCURACY TEST (Continued)
NA-5
FIGURE F.9 VOLTMETER PC BOARD AND TEST POINTS
L6685-[ ] METER
TP4
TP5
517
518
510
510C
601
602
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC