Filter
Top Products
F-78
TROUBLESHOOTING & REPAIR
F-78
PROCEDURE
1. Remove input power to the NA-5.
2. With the 5/16" nutdriver locate and
remove the four screws holding the
tach cover to the wire feed drive
motor. See Figure F.13
3. Using the 5/16" nutdriver remove the
two screws from the connection box
cover.
4. Locate and disconnect the in-line
connectors from leads #510A,
#525A and #555.
5. Using the phillips head screwdriver,
remove the two screws from the
pick-up assembly cover . See
Figure F.14. Remove the cover.
6. Hold the nut in place with the 3/8"
wrench. With the phillips head
screwdriver, remove the locking
screw from the rotating disc. See
Figure F.15
TACH PC BOARD REMOVAL AND REPLACEMENT (Continued)
NA-5
FIGURE F.13 DRIVE MOTOR, TACH COVER, AND CONNECTION BOX
WIRE
DRIVE
MOTOR
MOUNTING
SCREWS (x4)
TACH COVER
PICKUP
ASSEMBLY
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC