Filter
Top Products
PRECISION TIG 185
TROUBLESHOOTING & REPAIR
F-51 F-51
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
HIGH VOLTAGE TRANSFORMER
REMOVAL AND REPLACEMENT PROCEDURE (Continued)
REPLACEMENT PROCEDURE
1. Carefully position the new high volt-
age transformer in place in the two
rear mounting insulators. See Figure
F.12.
2. Install the front mounting insulators
and mounting screw.
3. Using the phillips head screwdriver
tighten all four mounting screws mak-
ing certain the insulators are posi-
tioned correctly.
4. Reconnect the two primary leads.
5. Reconnect the two secondary leads
to the high frequency arc starter
board assembly.
6. Replace any previously removed
cable ties.
7. Replace the case wrap-around
cover.
FIGURE F.12 HIGH VOLTAGE TRANSFORMER MOUNTING INSULATORS
FRONT MOUNTING
INSULATORS
SLOTTED REAR
MOUNTING INSULATORS
NOTE: On some machines the
mounting screw configuration may be
different.