Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
F-11
TROUBLESHOOTING & REPAIR
F-11
WIRE-MATIC 250
MAIN TRANSFORMER TEST (CONTINUED)
TEST PROCEDURE
The ON/OFF POWER SWITCH will be
"hot" during these tests.
__________________________
NOTE: Secondary voltages will vary
proportionably with the primary input
voltage.
1. Disconnect the main input power
supply to the machine.
2. Remove the Case Top and Side
Panels with a 5/16" nut driver.
3. Locate Plug J3 and Plug J6 on the
G2332 Control PC Board.
NOTE: The location of Plugs may vary
depending on the machine code.
FIGURE F.1 - G2332 Control PC
Board Main Transformer Test Points.
G2332
WM-250 CONTROL
J2
J7
J4
J10
J6
J9
J3
J5
#202
(1J3)
#204A (2J3)
#203
(3J3)
#206
(4J6)
#209
(7J6)
#208
(16J6)
J1
WARNING