Makita 2030N Planer User Manual


 
MAINTENANCE
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection and maintenance.
Replacing carbon brushes
.Remove and check the carbon brushes
regularly. Replace when they wear down
to about
6
mm
(1/4")
or
less.
Keep the
brushes clean and free to slip in the
holders. Both brushes should be changed
at
the same time. Use only Makita carbon
brushes.
Remove the screws that hold the chip
cover and the switch cover. Set the speed
change lever in the neutral position and
remove the switch cover. Open the chip
cover.
.Use
a
screwdriver to remove the brush
holder cap
as
shown on the figure.
U
6mm
(1/4")
I
Fig.
2Z
Fig.
29
Fig.
30
17