ADDITIONAL SAFETY RULES FOR JOINTER
1. Maintain the proper relationships of infeed and outfeed table surfaces and cut-
terhead blade path.
2.
Do
not perform jointing operations on material shorter than
140
mm (5-112
inches), narrower than
19
mm (3/4 inch), or less than 12.7 mm (112 inch) thick.
3.
Do
not perform planing operations on material shorter than
140
mm (5-1/2
inches), narrower than
19
mm (314 inch), wider than 155 mm (6-118 inches)
or thinner than 12.7 mm (1/2 inch).
4.
Support the workpiece adequately at all times during operation.
5.
Do
not back the work toward the infeed table.
6. Always use hold-downlpush blocks for jointing material narrower than 76.2
mm
(3
inches), or planing material thinner than 76.2 mm
(3
inches).
SAVE THESE INSTRUCTIONS.
ADDITIONAL SAFETY RULES FOR AUTO-PLANER
1.
Two or more pieces of narrow
but
similar thickness stock can be passed
through the auto-planer side by side.
However, allow some spacing between the stock to permit the feed rollers
to grip the thinnest piece.
Otherwise, a slightly thinner piece could be kicked back by the cutterhead.
WARNING
For Your Own Safety, Read Instruction Manual Before Operating Jointer
1.
Wear eye protection.
2.
Never perform jointing or planing operation with cutter head or drive guard
3.
Never make jointing or planing cut deeper than
3.2
mm
(1/8 inch).
4.
Always use hold-downlpush blocks for jointing material narrower than 76.2
mm
(3
inches), or planing material thinner than 76.2 mm
(3
inches).
5.
Do
not attempt to perform an abnormal or little-used operation without study
and the use of adequate hold-down1push blocks, jigs, fixtures, stops, etc.
removed.
SAVE THESE INSTRUCTIONS.
6