Filter
Top Products
ADDITIONAL SAFETY RULES
1.
2.
3.
4.
5.
6.
7.
8.
9.
IO.
11.
12.
13.
14.
15.
16.
Don't use the tool in presence of flammable liquids or gases.
Handle the blades very carefully.
Check the blades carefully for cracks or damage before operation. Replace
cracked or damaged blades immediately.
Be sure the planer blade installation bolts are securely tightened before
operating.
Sharpen both blades evenly, or replace both blades or both cutterhead covers
at the same time.
Never make jointing or planing cut deeper than
3.2
mm
(1/8
inch).
Remove nails and clean the workpiece before cutting. Nail, sand or other
matter can cause blade damage.
Make sure the blade is not contacting workpiece before the switch is turned
on.
Wait until the blades attain
full
speed before cutting.
Keep hands away from rotating parts.
Stop operation immediately
if
you notice anything abnormal.
Always switch off and wait for blades to come to a complete stop before
adjusting any parts, cleaning out chips or approaching the blade.
Never stick your finger into the chip chute. Chute may jam when cutting
damp wood. Turn off the planer-jointer and then clean out chips with a stick.
Do
not touch blades right after operation, they may be extremely hot and
could burn your skin.
Don't abuse cord. Never yank cord to disconnect from receptacle. Keep cord
from heat, oil and sharp edges.
Do not use auto-planer and jointer at the same time. Overloading of the
motor can occur.
5