Filter
Top Products
JOINTER
1.
Cutting depth
Set
the depth of cut with
the
depth
adjustment knob while watching the
graduation on the
scale
plate.
Fig.
6
2.
Fence angle
(0
-
45')
Set
the depth of cut to
"0"
graduation.
Loosen the thumb screws holding the
fence in place. Pull out the fence by at
least
25
mm
(1")
and tighten the thumb
screws.
Loosen the hex bolts
(A)
and
(B)
and
tilt
the fence.
Fig.
7
At the desired angle, tighten the hex bolts, making sure that the bolt
(A)
is
tightened
first and the bolt
(BI
second. (Refer to
Fig.
7).
About
0.5
mm
(1/64")
clearance be-
tween, the lower edge
of
the fence and the table top
is
necessary for the correct setting.
3.
Switch action
To start the tool, the key and the
ON-
button must be pressed in.
Press the OFF-button to stop.
The
tool
is
switched off automatically
when the electric current
is
cut
off.
CAUTION
:
When not using the tool, remove the
key. (This prevents unauthorized opera-
tion.)
Fig.
8
9