Filter
Top Products
PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 15
■
DO NOT use the handle bars and/or front pointer as lifting
points.
■
ALWAYS use ramps capable of supporting the weight of the
saw and the operator to load and unload the saw. If the saw
must be lifted, always use two people. Never attempt to lift
the saw by yourself.
■
NEVER tip the engine to extreme angles as it may cause oil
to gravitate into the cylinder head making the engine start
difficult.
■
NEVER transport the saw to or from the job site with the
blade mounted.
PS7060 MULTIQUIP SAW — RULES FOR SAFE OPERATION
Transporting (Via truck/trailer)
■
ALWAYS shutdown engine before transporting.
■
Tighten fuel tank cap securely and close fuel petcock to
prevent fuel from spilling.
■
Drain fuel when transporting saw for long distances or over
bad roads.
■
Use appropriate lifting equipment to ensure the safe
movement of the saw.
■
Do not use the handlebars or front pointer as lifting points.
■
When placing the saw on a truck-bed for transport,
always
tie-down the saw.
■
Do not use the handlebars or front pointer as tie-down points.
■
Never attempt to tow the saw untrailered behind a vehicle.
■
Never transport the saw with the blade mounted.
■
If the saw is being transported via a trailer, make sure the
trailer complies with all local and state safety transportation
laws. Refer to the following "
Towing Safety Precautions"
for basic towing techniques.
Towing Safety Precautions (Trailer Usage)
Conform to
Department of Transportation (DOT) Safety
Towing Regulations
before transporting saw on public
roads.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
To reduce the possibility of an accident while transporting the
saw on public roads, always make sure the trailer that supports
the saw and the towing vehicle are in good operating condition
and both units are mechanically sound.
The following list of suggestions should be used when towing
your saw:
■
Check the tire air pressure on both towing vehicle and trailer.
Refer to the tire manufacturer's recommended pressure. Also
check the tire tread wear on both vehicles.
■
Use chock-blocks at each wheel when parked to prevent
trailer from rolling.
■
Use the trailer's swivel jack to adjust the trailer height to a
level position while parked.
■
Avoid sudden stops and starts. This can cause the trailer to
skid or jack-knife. Smooth, gradual starts and stops will
improve towing.
■
Avoid sharp turns.
■
Trailer should be adjusted to a level position at all times
when towing.
■
Raise and lock trailer wheel stand in the "UP" position when
transporting.
■
DOT requirements include the following:
Connect and test electric brake operation.
Secure portable power cables in cable tray with tie wraps.
■
ALWAYS make sure the vehicle and trailer directional,
backup, brake, and trailer lights are connected and working
■
DO NOT exceed the recommended highway speed when
towing.
■
ALWAYS make sure the trailer is equipped with "Safety
Chains " and ensure they are attached properly.
■
Make sure the hitch and coupling of the towing vehicle are
rated equal to, or greater than the trailer "gross vehicle weight
rating" (GVWR) of 6,000 lbs.
■
ALWAYS inspect the hitch and coupling for wear. NEVER
tow a trailer with defective hitches, couplings, chains, etc.
Saw Lifting and Loading Safety
This Saw is very
heavy
. Use proper heavy lifting procedures
and DO NOT attempt to lift the by the guards.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
NEVER stand under or allow anyone else to stand under the
saw while it is being lifted.
DANGERDANGER
DANGERDANGER
DANGER