Filter
Top Products
PAGE 38 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)
PS7060 MULTIQUIP SAW — LOADING AND TRANSPORTING
LOADING/UNLOADING AND TRANSPORTING THE SAW
Loading and Unloading
When LOADING, UNLOADING, or when on a STEEP
SLOPE, the engine MUST BE at 1800 RPM or above to
prevent loss of control.
WARNINGWARNING
WARNINGWARNING
WARNING
Figure 36. Tie-Down Points
Tie-Down Points
The saw is provided with holes at each corner of the lower frame
for easy tie-down during transportation.
The use of tie-downs to secure the saw during
transportation is highly recommended. ALWAYS secure
the saw during transportation to prevent unwanted
movement or shifting that could result in equipment
damage or injury to personel.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Lifting Point
AVOID INJURY!
Stay clear of the saw while it is being hoisted.
To avoid possible damage to the saw, use approved rigging
(minimum 3000 lb. test) when hoisting the saw.
WARNINGWARNING
WARNINGWARNING
WARNING
Figure 37. Lifting Point
The convenient single point for lifting the saw with a hoist is
located above the engine. (Figure 37.)
Night Light
Figure 38. Night Light
The night light, (Figure 38),can be used on either side of the saw
and can be extended and rotated for best illumination of the
cutting area. Aim the light then lock it in position by tightening
the lock knobs. The light can be removed for storage by loosening
the lock knobs, disconnecting the light cord and sliding the light
bar out of the saw.
To turn Lights ON, push the rocker-style switch located on the
instrument panel forward. To turn Lights OFF, push rocker switch
backward.
NEVER tie the back end of the saw down by strapping
across the handlebars. Damage to the SLH (Stay Level
Handles) System will occur.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION