Filter
Top Products
PAGE 54 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)
3
8
5
7
2
6
9
4
4
1
PS7060 MULTIQUIP SAW — MAINTENANCE
Figure 68. Hydraulic System Drains
To prevent hydraulic pump damage, pre-fill the filter with
oil prior to installing it.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
1. Place an oil pan beneath the Blade Shaft Housing (1).
2. Remove the drain plug from the bottom of the Blade Shaft
Housing.
3. Collect and dispose the used oil (and filter) in accordance
with ordinances and regulations of your area.
4. Remove used oil filter.
5. After oil is drained, reinstall drain plug.
6. Pre-fill and install a new oil filter.
7. Add oil to the system reservoir.
8. The reservoir will need to be filled several times.
9. Run the engine for 5-10 minutes to cycle the oil throughout
the system.
10. Add oil as required.
11. Repeat process until oil level is stable after running engine.
1. Hydraulic Reservoir
2. Filter
3. Pump
4. Wheel Motor
5. Engine Pivot Cylinder
6. Engine Tilt Cylinder
7. Motor
8. Pump Body
9. Lift Cylinder
1
2
3
Figure 67. Hydraulic System