Filter
Top Products
PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 41
F
C
TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE
-20
0
20
SAE 15W-40
SAE 20W-50
SAE 10W-30, 10W-40
32 40 60 80 100
-30
-20
-10
0
10
20 30 40
SAE 0W-30, 0W-40
SAE 5W-30, 5W-40
PS7060 MULTIQUIP SAW — MAINTENANCE
Table 9. Recommended Viscosity Grades
Figure 42. Oil Filter
2. Be sure to coat the
seal
of the new oil filter with clean
engine oil.
3. Spin on new filter until seal make contact with surface, then
tighten additional 2/3 to 3/4 turn.
Oil Filter (125 Hours)
1. Replace the engine oil filter (Figure 42) every oil change
or 125 hours. Refer to your engine manual for specific
details to perform this operation.
2. Remove the oil filler cap (Figure 41, Item 13), and fill engine
crankcase with recommended type oil as listed in Table 3.
Fill to the upper limit of dipstick.
3. Crankcase capacity with filter replacement is 8 quarts, (7.57
liters). Refer to Table 9 for recommended viscosity grade
for temperature range.
Checking Engine Oil
1. Check engine oil level daily before starting the engine.
2. When checking or adding oil, place the machine so the
engine is level.
3. Pull the engine oil dipstick from its holder, (Item 10, Figure
41).
4. Determine if engine oil is low. Oil should be between the
upper and lower limit (add oil) lines.
5. If oil is below the "Add Engine Oil" line, add oil up to the
upper limit on the dipstick. Allow enough time for any oil to
make its way to the oil pan before rechecking.
DO NOT overfill the oil pan with engine oil. Always keep the
engine oil level at the upper limit lines on the dipstick due to
the tilting of the engine during operation.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
8. Fuel Filter
9. Throttle Lever
10. Dipstick (engine oil)
11. Engine Oil Filter
12. Drain Plug (engine oil)
13. Filler Port (engine oil)
14. Crank Shaft V-pulley
15. Cooling Fan
16. Adjustment bolt (V-belt tension)
17. Belt Guard
18. Fan Cover
19. Oil Cooler
1. V-belt
2. Rocker Arm Cover
3. Fuel Injection Pump
4. Alternator
5. Starter motor
6. Flywheel
7. Air Filter/Cooling System
Figure 41. Engine Service Areas
1
2
1. Engine Oil Filter
2. Filter Seal
Changing Engine Oil And Filter
1. Change the engine oil after the first 5 hours of use, then
change every 6 months or 125 hours.