Multiquip PS706026 PS706030 Cordless Saw User Manual


 
PAGE 32 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)
PS7060 MULTIQUIP SAW — FUELING THE SAW
Fueling the Saw
This saw features an 8 gallon, clear, molded plastic fuel tank for
ease of checking the fuel level. It has a central drain and a shutoff
valve. The fuel tank cap is located at the front of the control panel
console and a fuel gauge tube is featured on the front of the
console.
Avoid spilling fuel on the control panel or engine. Clean up
fuel spills to avoid falls from slipping.
DO NOT overtighten the fuel tank cap.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Use DIESEL FUEL ONLY.
NEVER use gasoline or fuels not specifically for use in the
Deutz Diesel engine.
WARNINGWARNING
WARNINGWARNING
WARNING
DO NOT crank the engine without fuel in the line between
the tank and the primary fuel pump to prevent damage to the
primary fuel transfer pump.
WARNINGWARNING
WARNINGWARNING
WARNING
Saws
UP TO
S/N ZC3700225 utilize a fuel primer bulb when
fueling the saw for the first time or re-filling after running out of
fuel. Locate the fuel primer bulb inside the console beneath the
fuel tank, (A in Figure 25) and squeeze the fuel priming bulb
until it fills with fuel, (it will become firm when properly primed),
priming the fuel transfer pump.
Saws
AFTER
S/N ZC3700225 utilize a fuel primer button built
into the engine transfer pump. (B in Figure 25)
Figure 24. Fuel Gauge
Figure 25. Fuel Primer Bulb (A) or Button (B)
DO NOT store with fuel in the tank for an extended period of
time. Completely drain fuel system (tank, lines, etc.) if the
unit is to be put into long term storage. For shorter or
intermediate periods of time the tank should be filled to avoid
condensation that could cause contamination of the fuel.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Priming the Fuel System
Storage With Fuel In System
Handle fuel safely.
Motor fuels are highly flammable and can
be dangerous if mishandled.
DO NOT smoke while refueling.
DO NOT attempt to refuel the saw if the
engine is hot or running.
1. Determine if the engine fuel is low. ( Figure 24)
2. If fuel level is low, remove the fuel filler cap and fill with
diesel fuel. (Cetane fuel number 45 or greater).
A
B